Difference between revisions of "How to get good coordinates (when hiding)"

From Cacheopedia
Jump to: navigation, search
m (Categorized)
Line 1: Line 1:
 
[[Category:Guides]]
 
[[Category:Guides]]
Many cachers complain when they find a cache and the coordinates are 75 feet away. To help prevent this  from happening to your caches, use this method:
+
Many cachers complain when they find a cache and the coordinates are 75 feet away. To help prevent this  from happening to your caches, use one of the following methods:
  
 +
== Method One ==
 
'''step one'''
 
'''step one'''
 
Walk up to your cache and hold the GPS as close to it as possible without blocking out too many satellites.
 
Walk up to your cache and hold the GPS as close to it as possible without blocking out too many satellites.
Line 24: Line 25:
  
  
 +
== Method Two ==
 +
Here is another method which works very well for units that auto-average like Magellan's SporTrak series.
  
'''Some tips for getting good readings'''
+
* Place the unit on the cache or very near it.  You can suspend the unit over the cache from a branch or walking stick.
----------
+
* Ensure you have good satellite geometry and signal at the point you are marking.
 +
* Let the unit average for about 3 to 5 minutes.
 +
* Move the unit just enough to break auto-averaging and immediately replace in the same spot.
 +
* Let the unit now average for at least 10 minutes if you have good signal and coverage, longer when signal and coverage is poorer.
 +
* Mark the waypoint.
  
If the cache is in an area with very bad reception, go into a nearby area with good reception, get a good number of sats, then walk in a straight line toward your cache before taking a mark.
+
''Magellan SporTraks are notorious for their "sling shot effect" so obtaining accurate readings are completely different from many other units, but the above method will yield very accurate results''
  
Always wait at least 2 minutes before taking a mark, even with lots of sats. This way, the GPS has time to average the signal from the satellites and get more accurate coordinates.
 
  
Read the users manual. It should tell you how to hold your GPS to get better reception. For Magellans, at least, you should hold the GPS vertically, so that the top is pointing up.
+
 
 +
== Some tips for getting good readings ==
 +
* If the cache is in an area with very bad reception, go into a nearby area with good reception, get a good number of satellites, then walk in a straight line toward your cache before taking a mark.
 +
 
 +
* Always wait at least 2 minutes before taking a mark, even with lots of satellites. This way, the GPS has time to average the signal from the satellites and get more accurate coordinates.
 +
 
 +
* Read the users manual. It should tell you how to hold your GPS to get better reception. For Magellans, at least, you should hold the GPS vertically, so that the top is pointing up.
 +
 
 +
* Pretend to place a cache in your backyard or nearby common area.  Use one of the above methods to mark the "cache."  Return on a different day and repeat the procedures to gain confidence ''your'' method is working for you.

Revision as of 16:15, 22 May 2005

Many cachers complain when they find a cache and the coordinates are 75 feet away. To help prevent this from happening to your caches, use one of the following methods:

Method One

step one Walk up to your cache and hold the GPS as close to it as possible without blocking out too many satellites.

step two Wait for 3-6 minutes without moving your GPS, then take a mark.

step three Repeat steps 1 and 2 after walking away and coming back from several different directions.

step four Repeat all the steps on a day with different weather

step five Go back to your cache and, after waiting several minutes, find out which waypoint is the closest to the actual location.

step six Repeat step five until it becomes obvious which waypoint is actually the closest to the cache.


If you are not that much of a perfectionist, then you can skip step four.


Method Two

Here is another method which works very well for units that auto-average like Magellan's SporTrak series.

  • Place the unit on the cache or very near it. You can suspend the unit over the cache from a branch or walking stick.
  • Ensure you have good satellite geometry and signal at the point you are marking.
  • Let the unit average for about 3 to 5 minutes.
  • Move the unit just enough to break auto-averaging and immediately replace in the same spot.
  • Let the unit now average for at least 10 minutes if you have good signal and coverage, longer when signal and coverage is poorer.
  • Mark the waypoint.

Magellan SporTraks are notorious for their "sling shot effect" so obtaining accurate readings are completely different from many other units, but the above method will yield very accurate results


Some tips for getting good readings

  • If the cache is in an area with very bad reception, go into a nearby area with good reception, get a good number of satellites, then walk in a straight line toward your cache before taking a mark.
  • Always wait at least 2 minutes before taking a mark, even with lots of satellites. This way, the GPS has time to average the signal from the satellites and get more accurate coordinates.
  • Read the users manual. It should tell you how to hold your GPS to get better reception. For Magellans, at least, you should hold the GPS vertically, so that the top is pointing up.
  • Pretend to place a cache in your backyard or nearby common area. Use one of the above methods to mark the "cache." Return on a different day and repeat the procedures to gain confidence your method is working for you.
Personal tools